Quick and E-Z lawn Sprinkler
6,086
visitas
286
descargas
3
colecciones
0 comentarios
Cargando comentarios...
Quick and E-Z lawn Sprinkler
3D
Published 2014-12-09T12:19:26+00:00
18
0
Add to Collection
Descripción
I was once asked if I could design a one piece sprinker that could be printed in one run with no moving parts. This little guy is an easy print. It produces a water spread of about 30' around at about 45-50 psi (local municipal water pressure). You might need to print it using a couple extra wall to prevent water intrusion into the main body of the unit (I printed mine at .2 with 3 walls, and .1 with 2 walls). I also recommend using a standard hose washer to prevent leaking around the coupling.
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 30 g of filament and takes 171 minutes.
Información técnica
Date published | 09/12/2014 |
¿Cuándo tiempo lleva? | 171 - 181 minutos |
Cantidad de filamento | 30 g |
Dimensiones | 113 x 84 x 50 mm |
Complejidad | Medio |
Más información
Archivos