Raspberry Pi Security Camera
Raspberry Pi Security Camera
Published 2017-09-08T09:18:25+00:00
Here is a simple camera case for the Raspberry Pi version 2 camera. The extra gasket (gasket.stl) is to enable the fitment of a metal shim with a pinhole drilled into it. Anything larger than 0.60uM will work. Please remove the existing lens before attempting to use a pinhole. This does "destroy" the lens, however, careful removal using sharp wire cutters on the corners of each of the camera can result in the lens being removed intact. I know, I've done it numerous times.
I won't be held responsible for destroying your PiCam if you install a pinhole lens.
I have used these extensively for my PhD thesis works.
For assembly instructions, please see the below video.
The whole assembly is held together with 3 M3 35mm socket head bolts. Such as those found at https://www.bolt.com.au/m3-35mm-socket-head-cap-screws-p-26429.html.
If you find that the ball joint is too loose, try increasing your printer tolerances or, optionally, insert a grub screw into the flat portion of the ball. Such a grub screw includes a cone point that can be found at https://www.bolt.com.au/m3-10mm-grub-screw-cone-point-p-28353.html. This can then be adjusted out until a firm grip is reached.
A slot in the base allows an 8mm button magnet to be placed firmly for securing to magnetic surfaces. These magnets can be obtained from Element 14: http://au.element14.com/duratool/d01766/magnets-rare-earth-8-x-3mm-pk10/dp/1888095
Finally, an optional 5mm LED can be installed in the lower hole of the camera to allow increased Infrared illumination for night vision applications or just for fun to show when the camera is active. I suggest using an LED from the Kingbright range such as
http://au.element14.com/kingbright/l-53p3c/phototransistor-5mm-940nm/dp/2290444
(InfraRed)
or
http://au.element14.com/kingbright/l-1503ec/led-5mm-red-50mcd-617nm/dp/2335729
(Std Red)
Assembly instructions can be viewed at:
https://youtu.be/ZiJQV4724rU
Rafts:
No
Supports:
No
Resolution:
0.16
Infill:
0.25
The camera is printed out of Aurarum PLA Plus.
http://www.aurarum.com.au/high-temp-filament/770-pla-filament-black-175mm-net-weight-1kg-made-in-australia.html
Orientate the files so that the largest flat section is facing down. Do not worry about the unsupported hole for the magnet in the base or the arches where the ball joints go. These will print fine.
Date published | 08/09/2017 |
¿Cuándo tiempo lleva? | 245 - 312 minutos |
Cantidad de filamento | 48.2g |
Tecnología | FDM |
Complejidad | Muy fácil |
Sin apoyo | YES |