Rear Lens Cap (Pentax K-Mount)
6,595
visitas
280
descargas
7
colecciones
2 comentarios
Cargando comentarios...
Rear Lens Cap (Pentax K-Mount)
3D
Published 2016-02-08T12:45:12+00:00
45
2
Add to Collection
Descripción
Pentax rear lens cap for K-mount lenses. Designed to fit more tightly than the Pentax caps, especially on 3rd party lenses. These caps are also about 20% shorter but wide enough to seal against the o-rings on weather resistant lenses.
Instructions
Tolerances are very tight on this design so I'm not sure how well it will work with other printers. Support material may be needed in some cases, but I've been printing without using ABS and MadeSolid PET+. Without support, my printer usually leaves a single loose line of filament that needs to be removed to keep it from snagging on the lens bayonet.
Información técnica
Date published | 08/02/2016 |
Tecnología | FDM |
Más información
Archivos
jeyers 5x5 manual mesh leveling.