Rim Penholder
3,662
visitas
138
descargas
0 comentarios
Cargando comentarios...
Rim Penholder
3D
Published 2015-05-18T19:20:58+00:00
12
0
Add to Collection
Detalles de impresión
Print at 0.2 mm layer height, with 10% infill. This uses 68 g of filament and takes 17 hours minutes. This design is quite difficult to print (in my opinion). I suggest to print it in possition as it should stand on the desk after print (at the photos). Personally printed with support (only touching buildplate) with 80 deg. overhang angle with 30 brim lines to have good adhesion to the platform.
Información técnica
Date published | 18/05/2015 |
¿Cuándo tiempo lleva? | 1020 - 1030 minutos |
Cantidad de filamento | 68 g |
Dimensiones | 107 mm x 107 mm x 60 mm |
Complejidad | Fácil |
Más información
Archivos