Sandcastle Bottle of Beer Mould
Sandcastle Bottle of Beer Mould
3D
Published 2017-01-09T10:54:29+00:00
Ninety-nine bottles of beer on the beach, ninety-nine bottles of beer…
To use, start by scooping up sand (or snow) into each part, and squeezing them together, making sure excess material is squeezed out. Stamp a bit more sand into the base to ensure it’s compacted solidly, then gently bump the mould onto the ground as you remove the parts.
This may take a little practice to find the right wetness of sand and get right, but you’ll be stacking bottles of beer in no time!
The Sandcastle Bottle of Beer Mould is also available on Etsy for would wide distribution!
Some assembly is required for each mould part. The halves have been broken into smaller parts for ease of fabrication, but can be neatly glued together with super glue.
| Date published | 09/01/2017 |
| Dimensiones | 60mm x 60mm x 185mm |
| Tecnología | FDM |