Scallop
Scallop
3D
Published 2016-05-16T13:01:43+00:00
This scan originates from Oliver Laric's initiative 'threedscans'. It is part of an ongoing project by Laric, titled 'Versions', which deals with historical and contemporary ideas relating to image hierarchies. Every model produced by Laric is free to be downloaded and used without copyright restrictions. If you use the models please write to stw@myminifactory.com and contact@threedscans.com
I would suggest printing the piece on the "hinge" portion of the shell. the natural slopping structure should help save on some support material clean up. I also suggest a brim to help balance the piece as it is quite narrow at the point of contact with the print bed. I personally used a .15mm layer height with a .4mm nozzel and 20 percent infill.
| Date published | 16/05/2016 |
| ¿Cuándo tiempo lleva? | 180 - 220 minutos |
| Cantidad de filamento | 38.8 grams |
| Dimensiones | 67.7mm x 21.4mm x 77.3mm |
| Tecnología | FDM |
| Titulo | Scallop |
