Hello everyone. I designed this bracket in Fusion360 to attach a leveling dial to an Artillery Sidewinder X1, but it should in theory be attachable to any 3D printer, provided you find a suitable spot for it. The bracket itself is just attached to a flat spot on the Sidewinder's hot end housing with double sided mounting tape, which allows the dial itself to be removed whenever you're not using it. As long as you make sure the bracket doesnt touch any moving gears, you shouldn't have a problem. There's no specific spot for the bracket to be attached to, so you're going to have to play around with it until you find a spot where the needle is just barely touching the bed, but not low enough that it scrapes across the bed while its moving.
The dial I'm using is approximately 53mm in diameter, but I attached the Fusion360 file to this post for you guys to modify for your specific dial.
Here's an Amazon link to the specific dial I'm using:
And here's the specific mounting tape I am using:
If you guys have any modifications or suggestions to make this better, please let me know.