I designed this mic stand because I needed something very specific. Among my requirements, I was looking for a firm fit for my SM58, nearly 20 cm tall, angle adjustment, and a stable base like a good commercial mic stand. 

I'm working to add different "clips" for different microphones (english is not my native language, I don't know if "clip" is the right word) so stay tunned.

If it is printed with the proper infill in the appropriate areas, it is designed to last many years. My print has 3 perimeters and variable infill (I'm gonna add as soon as possible a new image so you can see what I did). There's no need for supports.

I recommend a screw of about 9.4 millimeters in diameter and 4cm in length with its corresponding nut, and felt to protect your microphone.

If this design is useful to you, a small tip will encourage us to share new and better ideas. You can do it through Paypal, thank you very much!

LV-481.com

Note: since july 2017 My Mini Factory is the only place where we (Gina and Alexei) share our designs, please tell us if you see this design in somewhere else.