Silver Stone/Linus Tech Tips dual headphone wall mount competition entry by Richard Barrie
Silver Stone/Linus Tech Tips dual headphone wall mount competition entry by Richard Barrie
Published 2015-05-21T11:12:44+00:00
This is an entry into the SilverStone wall-mounted headphone stand design competition in collaboration with Linus Tech Tips.
Please cast your vote for this entry by downloading it.
You can view Linus' video about the competition here:
NOTES: "arm" is intended to be geometrically symmetrical including mounting holes so orientation doesn't matter "screws" are essentially 4mm diameter dowel for the purpose of 3d printing, if dowel can be sourced/cut to size, this may be easier than printing the "screws" short screw is 5mm in total length, long screw is 15mm in total length 1-attach end of "arm" to base using 2x"long screws" 2-attach "neck arm connector" to end of "arm" using 2x"short screws" 3-attach head to "neck arm connector" using 4x"short screws" 4-attach assembly to wall through 4 remaining holes in base using "long screws"
Date published | 21/05/2015 |