Simple M1.6 Nut Driver
Simple M1.6 Nut Driver
3D
Published 2018-10-16T08:12:22+00:00
Summary
M1.6 nut driver for tightening and loosening M1.6 nuts. It's compact in size and is hollow to allow a shaft to go through the middle if needed. Great for small scale radio controlled vehicles that use M1.6 fasteners and wheel nuts.
Print Settings
Rafts:
No
Supports:
No
Notes:
It is important to ensure your printer is dimensionally accurate when printing to ensure that a M1.6 nut will fit snug. Using a smaller size nozzle such as a 0.3mm or less is recommended.
Post-Printing
If a nut does not fit all the way, place it on flat and tap it with a hammer to get it to fit. You will probable need to thread the nut onto a shaft and pull to remove it. The driver will get better with use as it gets worn in.
| Date published | 16/10/2018 |
| Sin apoyo | YES |
