Small case for Raspberry Pi A+
Sin soporte
Destacado
6,875
visitas
308
descargas
4
colecciones
0 comentarios
Cargando comentarios...
Small case for Raspberry Pi A+
3D
Published 2015-09-25T17:47:47+00:00
34
0
Add to Collection
Descripción
Simple Case for a RaspberryPi A+. Pick a case and a lid that suit your needs. 4x M2.5x5 or M2.5x6 and, depending on the box, 4x M2.5 nuts are needed to mount the Raspberry Pi A+
Información técnica
Date published | 25/09/2015 |
¿Cuándo tiempo lleva? | 60 - 180 minutos |
Cantidad de filamento | 30 grams |
Dimensiones | 70 x 61 x 20 mm |
Tecnología | FDM |
Complejidad | Fácil |
Sin apoyo | YES |
Más información
Archivos
Printed on an M3D micro using Sunset Orange 3D Ink™, which I think is PLA. Quality: Very High Quality (150 microns) Fill: (250 microns) Print Attempts: first attempt (base), second attempt (lid) (first attempt was printed with raft which was a nuisance without the correct tools to remove it). Raft: yes (base), lid (no) Printing Time: a few hours for the base, about an hour for the lid. Observations: 1. The slot for the camera cable is not at the same position horizontally as the connector, so a loop has to be fed into the box to stop the cable form being twisted. 2. When closed the lid is slightly bent, but this could probably be fixed by trimming the hinges / holes a little.