Specialty Polypanel: Magnetic Square
Specialty Polypanel: Magnetic Square
Published 2019-05-12T18:10:11+00:00 • Remix de Polypanels // Square
Submission for Polypanel Competition. This part allows you to put a magnet that is roughly 20mm in diameter and 5mm height. No supports needed, I suggest to print with 70% or higher infill. After print, gently remove clamp from base of part. The clamp is located on the side with the gap. This allows the part to grab the magnet and helps prevent the magnet form falling out. This print can be used to hang polypanel creations on the fridge, any magnetic object, including another polypanel magnets. Expand the possibilities with this unique panel.
-70%+ Density
-No supports
-Made for 20mm diameter magnet with 5mm height
-Remove the clamp portion from the base of part, clamp is located at the partition in the magnet housing.
Date published | 12/05/2019 |
¿Cuándo tiempo lleva? | 32 - 33 minutos |
Cantidad de filamento | 1.74m |
Dimensiones | 50mm x 50mm x 7.7mm |