Spool holder
2,688
visitas
144
descargas
0 comentarios
Cargando comentarios... 
Spool holder
3D
Published 2018-07-05T22:12:15+00:00
7
0
Add to Collection
Descripción
This is a high-quality spool holder I designed for my own use but upon realising how useful this could be for others I have published it.
Notes
If your spool is too large, remove the bottom rods as these are for extra support.
Assembly
Slide the large rod into the top hole of one frame, repeat this with the smaller rods on the same frame. Add the spool so that the center gap has the large rod going through it. Place the second frame on top of the rods and push it down. Now, position the rods so that the frames are in between the sticking out rectangles, at this point rotate the rods ninety degrees. Now you are done!
Detalles de impresión
You will need to print
- Frame 1 (1X)
- Frame 2 (1X)
- Large Rode (1X)
- Small Rod (2X)
Información técnica
| Date published | 05/07/2018 |
| ¿Cuándo tiempo lleva? | 1 - 2 minutos |
| Dimensiones | 140mm x 127mm x 5.850mm |
Más información
Archivos