Spool shaft for FormFutura & ColorFabb Filament for Mark Wheadon's big spool holder
4,403
visitas
96
descargas
0 comentarios
Cargando comentarios... 
Spool shaft for FormFutura & ColorFabb Filament for Mark Wheadon's big spool holder
3D
Published 2017-03-17T16:58:49+00:00
1
0
Add to Collection
Descripción
This is a shaft for the big spool holder of Mark Wheadon
http://www.thingiverse.com/thing:761893
I designed it to use it with FormFutura filament spools.
Update 2016-01-04: I mentioned that it also fits to ColorFabb's filament!
The outer diameter is 52mm.
The length is 100mm. (v1 - v3)
The length is 115mm. (v4)
The large diameter where the spool is placed is about 65mm in length.
There are 4 versions of it.
- v1 was the first design
- v2 was optimized regarding the necessary filament (supports are not symmetric between inner shaft and outer diameter)
- v3 was optimized to split the printing time (split into two parts, female and male)
- v4 is the same as v3 but instead of 65mm width or length it is now 80mm, because I got one spool which is 80mm wide
Información técnica
| Date published | 17/03/2017 |
Más información
Archivos