Stream Vase (with inserts!)
Stream Vase (with inserts!)
3D
Published 2019-03-25T12:47:36+00:00
You have @3DPrinTek on Twitter to thank for this one! He looked at the Weaver Vase and said "hey, could we put inesrts into those gaps?!". And so this design was born.
This isn't the same as the weaver, though, it's a new shape, but it shares the same characteristic of following mathematically-variable curves both horizontally and vertically. Unlike most of my previous multi-part vase mode models, this means we can't just slide the inserts in from the top! Nope! Instead, these go in from the side.
Oh, and inspired by the experience of the tolerance in the Spiral Twin Vase, there's no tolerance allowance in the insert here! That means it'll scale up just fine. However, I should point out that I haven't tried filling in all 12 of the gaps with inserts - maybe by the time you get all the way around it'll get a bit squishy? I'm not sure! If you want to try, then welcome to the adventure!
Enjoy!
This is a vase mode print, so set your slicer accordingly! Also, read the text above.
| Date published | 25/03/2019 |
| Sin apoyo | YES |
Cool design