superman logo bookmark
1,676
visitas
56
descargas
1
colección
0 comentarios
Cargando comentarios...
17
0
Add to Collection
Descripción
here is a superman logo bookmark. i made two of the both a different thickness but printed them at the same time with a layer height of 0.15.... i made the both in the tinker cad 3d design. i hope you all enjoy them and put then to good use when reading any books. oo i almost forgot i used supports but i used tree supports. there are also some stubbs in the middle of the design all i did was sand them down so that way it will fit in the books better.
Detalles de impresión
i used tree supports on cura 3.6.
Información técnica
Date published | 15/04/2019 |
¿Cuándo tiempo lleva? | 20 - 24 minutos |
Cantidad de filamento | zyltech bronze |
Dimensiones | 0.15mm |
Tecnología | FDM |
Más información
Archivos
Remix de