Tesla model S phone holder vent
Tesla model S phone holder vent
Published 2020-03-17T02:10:12+00:00
I was sick of my vent holders not keeping a grip in my Tesla. They either kept sliding around, or came of while accelerating.
I looked at some aftermarket phone holder, and I noticed they didn't grip the vent-blades but gripped on the walls of the vent. So I decided to design a similar grip, and it worked out perfectly.
This grip seems to hold very well, but I will keep improving if necessary.
As you can see, I simple bolted a round knob on the plate, but you can do whatever you want with it.
If the print still slides around, you can use some double-sided tape or glue some rubber band in the grip.
This way it won't slide around.
Printer Brand:
Anycubic
Printer:
Kossel
Rafts:
Yes
Supports:
No
Infill:
30%
Filament: 123-3d.nl PLA White
Date published | 17/03/2020 |
¿Cuándo tiempo lleva? | 40 - minutos |
Sin apoyo | YES |