Tevo Little Monster 400 mm printing glass bracket
Tevo Little Monster 400 mm printing glass bracket
3D
Published 2017-11-28T13:24:27+00:00
The original glass base of my Tevo Little Monster get broken after a few prints then I decided to add a new glass over it instead to change the original. I put a 400 x 8 mm tempered glass found on the internet (cheaper than to order one cut with original measures). Then I had to design something to block it in position. These brackets are very tight (designed for a straight edge glass) and it's possible that you have to grind them a bit and/or make the screw's holes a bit bigger. I hope they will be useful for somebody.
Rafts: No
Supports: No
Resolution: 0.20
Infill: 20%
Printed in ABS (better to avoid PLA because the bed can be heated to high temperature) using:
4 top/bottom layers
3 walls
80mm/s
To install them, you will need longer M5 screws (I used M5 x 35mm).
| Date published | 28/11/2017 |
| Tecnología | FDM |
| Complejidad | Muy fácil |
| Sin apoyo | YES |
