The Paper Micro- The tiniest mag-fed pistol you'll ever print!
The Paper Micro- The tiniest mag-fed pistol you'll ever print!
3D
Published 2018-07-31T17:33:33+00:00
Tired of big complex guns and long prints?
This is the gun for you!
The Paper Micro is a gun created to be one of the smallest ever, but keeping the specs high:
-Removable grip to get the size even smaller
-Magazine fed gun
-Open bolt design
-Completely disassemblable
It shoots paper pellets made from 2x2cm paper well compressed into spheres.
(Bullet quality affects the functionality)
Just print, assembly, and throw it in your pencil case, ready to fire at your opponents at school or work!
You will need:
-1 M3x30 screw
-3 M3X12 (Or longer) screws with 3 nuts
-1 pen spring
After you print all the pieces, start with the receiver, the spring, and the M3X30.
Put the spring over the screw, and pass the screw trough the back hole from the inside.
Compress it and use a nut to keep it compressed.
Now put the trigger in place.
Slide the bolt into the barrel, then put the barrel in the gun.
Now you can unscrew the nut to relase the tension, let the screw head go into the bolt, so that the screw end sits flush with the back of the gun.
Now you can close the gun; take your three screws and put the closure in place.
You're done! Slide the grip on the gun, prepare some ammo, put the magazine in, and shoot!
| Date published | 31/07/2018 |
| Tecnología | FDM |
| Complejidad | Fácil |