TWISTY MEDALLION
TWISTY MEDALLION
3D
Published 2019-04-10T15:43:58+00:00
Here is a medallion...with a TWIST!
This print can be great for kids as an impromptu reward for doing something great, for sporting event finalists, for admiration to your spouse or whatever you like!
There is a small 27mm x 29mm ellipse relief in the center disk for a paper or 3D print to customize said medallion for whatever occasion!
Print out a few different colors to change the rings out for a multi color print!
PLA, Any color. No Supports, No Rafts. 0.2 -0.1 mm layer ht.
30-40% infill (triangle style)
2 Perimeters, 3 layers top/bottom.
Print slightly cooler (a few degrees) than your normal PLA setting just to ensure proper cooling of the spinner pegs, or turn your cooling fan up! Ironing helps for the top surface!
You can print as small as 80% scale on this design (picture shown is 80% scale). Any smaller and the pegs begin to fuse!
| Date published | 10/04/2019 |
| ¿Cuándo tiempo lleva? | 120 - minutos |
| Dimensiones | 80 x 80 mm |
| Sin apoyo | YES |
