Wristwatch Medicine Container
Wristwatch Medicine Container
3D
Published 2018-09-06T15:04:09+00:00
Wristwatch medicine capsule combo that helps remind you when it's time to take your crucial medicine :)
Steps:
1.Buy a cheap digital wristwatch from somewhere and take the bands off.
2. Then glue it to the lid of the container, making sure its properly aligned.
3. Use nylon strap segment 10mm wide and xxmm long for the new wrist bands.
4. Put a days worth of your medicine into the container.
5. Set an alarm so you don't miss a dose.
6. Repeat steps 4-5 daily or whenever
Print settings:
- 100% infill
- .2mm layer height
- 3 shells
The bottom of the container is the weakest part of the print, so make sure your first layer settings are thick.
Post Printing: you may want to thermoform the strap tabs. Just microwave a mug of water till its boiling, dunk the container tabs individually for about 10 seconds and bend it slightly down to make it wrap around the wrist better. USE CAUTION when doing this step as it is boiling water!
| Date published | 06/09/2018 |
| Sin apoyo | YES |
