Z-axis Adjustment Knob Mod for CR-10 and other printers with Z-thread
28,930
visitas
3,552
descargas
30
colecciones
10 comentarios
Cargando comentarios... 
Z-axis Adjustment Knob Mod for CR-10 and other printers with Z-thread
3D
Published 2017-12-15T03:22:28+00:00
555
10
Add to Collection
Descripción
My CR-10 has no built in option to raise or lower the z-axis so I've made this attachement that greatly improves the experience.
You need to raise the coupler about 1 cm on the z-axis where it's attached to the stepper motor so you can stick this on the top.
You may need to glue this into place, but for me it works as is.
Información técnica
| Date published | 15/12/2017 |
| Sin apoyo | YES |
Más información
Archivos
I've been wanting to print a z-axis manual adjustment knob for a while but just didn't see one that I liked... just printed yours and I gotta say, I really like it. I needed to apply some glue to the inside of the thread mount and I'm not sure how well it will hold over time but for right now, it's working great. Will also likely glue the handle knob so it's a little more stable while turning but overall, a great design and I thank you for it. You rock! -b