Zel's 500 Magnum Revolver Pen/Pencil Holder
Zel's 500 Magnum Revolver Pen/Pencil Holder
3D
Published 2020-05-06T12:27:11+00:00
This revolver cylinder pen holder is ready to hold all your precision writing instruments and keep them on target for all your paper slaying needs.
The standard model has 13mm holes for your normal pens and pencils. The 14mm Model is for larger ummm, Ammunition.
In the pack I have a non-spinning model and and a spinning model for each size. The spinning model uses a standard skateboard bearing. This bearing is small, so it requires some stabilizing dimples on the base. If requested, I will design the model to use a larger diameter bearing that could remove the dimples, but during the My Shirona Cyrus pandemic I was unable to requisition such bearings.
No support needed on any of the variations.
I suggest printing at .2 layer height and using the Auto variable layer height option in Prusa Slicer if avialabe to you.
| Date published | 06/05/2020 |
| Sin apoyo | YES |