As you might have noticed (3D printed) Pokémon started appearing on the streets. If you want to catch (print) them all, PokéMarvin is the best companion for you! :)

This little guy is just circa 30mm tall, so it makes a nice keychain or backpack zipper pull combining the symbols of 3D printing and the love for Pokémon.

This model is a bit tricky due to the tight tolerances. It can be nicly printed on a well leveled Ultimaker without any supports. Print all parts as orinented and print them slowly! I used 20 mm/s wall speed for most parts and 10 mm/s for the knob. Also print two of the knob piece at the same time to let them cool down before the next layer. 200-190 celsius seems to be just right. If printed correctly, all parts should snap together, but if you use it as a keychain or zipper pull maybe you should glue them together.