Skateboard Deck Shelf
Skateboard Deck Shelf
3D
Published 2017-03-29T15:39:50+00:00
I designed some brackets to turn a worn out skateboard deck into a shelf.
(Command strips did not work for me, had to install nail holes)
Printed successfully with PLA at 200 micron layer thickness, 3 shells, and 50% infill. It maybe sufficient to print this with 2 shells and less infill, but I was on the side of caution. I wanted this thing to be strong. I printed two at a time on a MakerBot Replicator 2.
There are two clearance holes that will align with the truck holes. The recommended screws for these are Flathead 8-32 x7/8" long, you will need 4.
I tried using command strips for this, but my wall was not flat enough so they would not stick properly. So I created some holes to attach the brackets with some sort of wall nail (depending on your type of wall).
| Date published | 29/03/2017 |
| Tecnología | FDM |
| Complejidad | Medio |
