Sneakers I by recreus
Destacado
41,593
visitas
2,872
descargas
43
colecciones
14 comentarios
Cargando comentarios... 
Sneakers I by recreus
3D
Published 2016-07-06T14:00:58+00:00
770
14
Add to Collection
Descripción
The Recreus Sneakers I has been created with a prusa i3 with a large working space (Y axis) and non-heated glass bed.
To print this sneakers we used orange Filaflex and blue Filaflex.
Detalles de impresión
SLICER: CURA 14.01 LAYER HEIGHT: 0.2mm PRINT SPEED: 90mm/s INFILL: 25% PRINTER: PRUSA I3 47 EU size
Información técnica
| Date published | 06/07/2016 |
| ¿Cuándo tiempo lleva? | - 16 minutos |
| Cantidad de filamento | 215 gr. |
| Tecnología | FDM |
Más información
Archivos
I liked the design and wanted to see if this is possible.... conclusion: a good test case how NOT to design a shoe! Several reasons: the thick side walls prevent the sole from flexing. The toe area might flex a little but that will really force the walls inside (very painful) or outside. The next BIG flaw is that all edges that are close to the skin are pointed inwards! that is also a big NO, it digs into the skin even before flexing. The heel "tooth", while looking interesting, is also a big "blister creator". The flat sole is very thin, certainly compared to the thick , up to 6mm walls..... Sorry that I can not find any positive traits, other than the looks. But it would be nice if you had mentioned that this was a show-case, not a functioning shoe.... And you might reverse your brand name when it is supposed to be on the sole, unless you want to leave it as a readable print on wet and muddy tracks....