TD3D Printing's Print of Mandalorian Helmet - v2
Community Print Impresión 3D de Mandalorian Helmet - v2
Published 2019-12-05T01:33:44+00:00
5
3
Impreso con: Creality CR-10
Material: PLA
Descripción
Printed in PLA at 0.2 mm layer heights. No internal supports. Raised the whole thing about 2mm and printed the whole thing on raft/support.
If I were to print it again I might try without supporting the back gap as well. I think it would bridge but might be a gamble. I'll add more pictures once post is done.
Excellent design. Thanks Rob!