SeanMurphy's Print of Suros PDX from Destiny
2,213
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Suros PDX from Destiny
Published 2017-07-18T15:44:21+00:00
7
0
Impreso con: Ultimaker 2
Material: PLA
Descripción
I printed this on the Ultimaker 2+. 10%infill was more than enough to keep it strong. I also used 3/16" wooden dowels to strengthen it as well as ultra gel control Locktite CA glue. I had some printing problems, but I used plastic wood from DAP to fill. It adheres really well on top of being cheap, easy to work with, and non-toxic. I used plasti dip to prime the surface, though I ended up with some problems on my painters tape taking up some spots. Acrylic paint to fix it up and acrylic gloss sealer to finish off the painting.