tuansacto's Print of Simple 16mm Dice // Single and Dual Color
Community Print Impresión 3D de Simple 16mm Dice // Single and Dual Color
Published 2020-01-09T07:33:41+00:00
0
1
Impreso con: BIQU Thunder
Material: PLA
Descripción
@MakeAnything @Leea: I find this a little weird. I'm using Cura4.4.1. If I used Center Selected Models, all the dots are not aligned with body according to preview and actual print. It's OK if I used Merged Models option in preview mode. Besides that I have another problem which is it prints the contour of body while printing the dots on the first layer as you can see in the picture. Is there any print order besides "one at a time"? Cura doesn't like one on top the other when slicing with this option turned on.