Petclaud's Print of KwikJet - The 3D Printable Jet Boat
2,194
visitas
2 comentarios
Cargando comentarios...
Community Print Impresión 3D de KwikJet - The 3D Printable Jet Boat
Published 2019-06-01T19:39:37+00:00
3
2
Descripción
I noticed the bearing where the shaft goes through the hole, leaks significant water. I have made a seal - printed in Ninjaflex - that holds up nicely. Have a look - you can maybe consider this also for your upgraded design. If you want I can sent you the STL's. It is a 1 mm seal - to be printed in flexible material and a 2mm press piece. The flexible seal hole diameter is just slightly smaller than the shaft, thereby blocking a lot of water. Use 8 mm M3 bolts instead of 6 mm. This keeps a lot of water out.