Milfyj's Print of KwikJet - The 3D Printable Jet Boat
3,186
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de KwikJet - The 3D Printable Jet Boat
Published 2019-09-05T02:39:02+00:00
16
0
Descripción
As I mentioned before, I deviated from the original bill of material's when it comes to the power system. I went with a 2200KV motor, because the local hobby store had one in stock. However, I've been running it with 4S batteries and it is an absolute blast! My biggest concern is that I cannot get a temp reading on the motor while running it. Hoping the water cooling is adequate. As for the brackish water, I imagine it would be fine. Like you said, as long as you rinse it out with fresh water afterwords, you shouldn't have issues. I believe you can use a bit of baking soda, soap and water (mixed) to clean it out. Then just run some fresh water through it to clean it completely. Happy boating :)