wickemu's Print of Lord of the rings - Tower Of Orthanc
Community Print Impresión 3D de Lord of the rings - Tower Of Orthanc
Published 2017-12-12T21:49:33+00:00
47
0
Impreso con: Robo 3D R1
Material: PLA
Descripción
Printed at 30% scale so it's approximately 50mm wide and 30cm tall. Printed at .1mm layer height with zero supports, though I did print some of the pieces upside down to make that easier. Extremely happy with how it turned out!
That said, the bottom is a little sloppy, and i feel like that is partially because of how it is modeled. the lines coming out of the structure don't seem like they're connected to the base, causing them to be printed as separate pieces, causing a lot of stringing. Minor issue overall though.
Printed with Vertigo Grey filament.