printy916's Print of Small case for Raspberry Pi A+
1,073
visitas
0 comentarios
Cargando comentarios...
Community Print Impresión 3D de Small case for Raspberry Pi A+
Published 2016-09-17T15:21:54+00:00
0
0
Impreso con: M3D
Material: PLA
Descripción
Printed on an M3D micro using Sunset Orange 3D Ink™, which I think is PLA.
Quality: Very High Quality (150 microns)
Fill: (250 microns)
Print Attempts: first attempt (base), second attempt (lid) (first attempt was printed with raft which was a nuisance without the correct tools to remove it).
Raft: yes (base), lid (no)
Printing Time: a few hours for the base, about an hour for the lid.
Observations:
1. The slot for the camera cable is not at the same position horizontally as the connector, so a loop has to be fed into the box to stop the cable form being twisted.
2. When closed the lid is slightly bent, but this could probably be fixed by trimming the hinges / holes a little.