MatBroomfield's Print of Ugolino and His Sons at the MET, New York
Scan The World
1,742
visitas
0 comentarios
Cargando comentarios... 
Community Print Impresión 3D de Ugolino and His Sons at the MET, New York
Published 2019-02-09T02:42:29+00:00
0
0
Impreso con: Creality CR-10
Material: PLA
Descripción
Used cheap PLA so translucency is horrible. Took well over an hour to clean up, and some parts still not clean.
Printed 20cm high .4mm layer took 26 hours on CR10s. Will probably print again with high quality stone or marble PLA at .12mm to bring out details. Few extended fingers to snap off but hands on face do not clean up well.
Scan could have been higher res, but overall pretty nice. Thanks.