sf1's Print of WALL-E
1,710
visitas
2 comentarios
Cargando comentarios...
Community Print Impresión 3D de WALL-E
Published 2019-05-20T03:33:54+00:00
1
2
Descripción
Printed out the body in MatterHackers program and the entire body literally prints completely off the designated area. Anyone else run into this? this is the second time I have seen this happen and right now I have honestly just resorted to letting it print. I have the support structures originating from the print bed and after my first layer was printing just fine, I let it go. Its almost as if the model shifted 1/4 of the way through.