Scorpionz... With Rotating Tail And Pincers That Nip!
Scorpionz... With Rotating Tail And Pincers That Nip!
3D
Published 2017-03-20T19:19:10+00:00
Print-in-Place design of a Scorpion. The tail rotates up and over. The pincers also rotate and, when squeezed, open to grab onto things. Another fun print!
Refer to instructions for print settings to ensure it is strong enough. NO SUPPORT REQUIRED.
After printing, carefully snap/cut away the Raft so you don't damage the legs or Pincers in particular. As soon as the Raft is removed the tail should rotate up and over the Scorpionz back and Princers move and nip/grab onto things. Take care when you first rotate the pincers so they break away cleanly. Just a gentle wriggle / twist should clean it away fine.
The standard design print is approx. 17 cm in length. This could be scaled up but scaling down will not work as it will affect internal clearances and could also make the joints too weak.
There is also a 'short' version (15.7cmlong) available which has one less link in the tail. It still works fine and will enable Scorpionz to be printed on machines with smaller build plates. If rotated to 45 degrees, the model will fit on a build plate measuring 13cm x 13cm.
Note: If you like this check out all my other designs and post pictures of your prints!
'Z-REX' https://www.myminifactory.com/object/30398
'Snails' https://www.myminifactory.com/object/30353
'Fish Fossilz' https://www.myminifactory.com/object/30368
'Bugz' https://www.myminifactory.com/object/30415
'Sharkz' https://www.myminifactory.com/object/30262
'Snakez' https://www.myminifactory.com/object/30413
'Ratz' https://www.myminifactory.com/object/30361
'Crocz' https://www.myminifactory.com/object/30274
'Woodpeckerz' https://www.myminifactory.com/object/30348
'Eaglez' https://www.myminifactory.com/object/30290
'Catz' https://www.myminifactory.com/object/30296
'Piranhaz' https://www.myminifactory.com/object/30424
This should print well on most 3D printers. On a Replicator 2 and 5th Generation Replicator they come out great with the following setting:
Raft On
0.20mm / Std Resolution
Minimum of 3 Shells / Recommend 4 Shells (to ensure it is strong)
35% infill
No Support
PLA (Not tested with ABS)
After printing, carefully snap/cut away the Raft so you don't damage the legs or Pincers in particular. As soon as the Raft is removed the tail should rotate up and over the Scorpionz back and Princers move and nip/grab onto things. Take care when you first rotate the pincers so they break away cleanly. Just a gentle wriggle / twist should clean it away fine.
Another tip is to put a drop of oil into each of the rotating joints to make it move smoothly and reduce the risk of any catching inside between fragments / lumps of filament that may have resulted during printing.. Free movement will help minimize the risk of fine parts breaking.
| Date de publication | 20/03/2017 |
| Technologie | FDM |
