3D Printed Single Coil Pulse Motor
3D Printed Single Coil Pulse Motor
Published 2017-03-28T15:39:03+00:00
As a single coil 3d printed pulse motor, it has very little torque, and is basically useless except for science fair projects and bragging rights, but it is fun to assemble, fine tune, and test.
Video of prototype at http://www.youtube.com/watch?v=t2n7DDyfocE.
Printed on a Replicator 2 using Makerware "standard" settings in PLA.
Caveats:
After winding my coil, it measured 24 ohms resistance. At 5Vdc, that equates to .208 amps. Measuring the operating temperature using an infrared temperature detector, the coil temperature was ambient (room temperature). Running the motor at higher voltages will result in higher currents and thus higher temperatures which could melt the spool structure. Mine runs fine at 3 to 6VDC, which results in a safe spool temperature for PLA.
Parts (aside from a 3d printer and filament):
1) Bearings, Duratrax 1/4" by 3'8" flanged, part number DTXC1433.
2) 30 gauge 200 ft. (Radio Shack part number 278-1345, red wire).
3) Coaxial power jack (Radio Shack part number 274-1583).
4) 5 Vdc 2 amp power supply (Radio Shack part number 273-1696) or equivalent.
5) Reed switch (Mouser part number 876-ORD2210V-2025).
6) 6 12mm diameter 3mm thick Neodymium magnets (I found mine at a local hardware store, but amazon.com has them at http://www.amazon.com/Neodymium-Magnets-12mm-inch-Disc/dp/B00CWGQ3XI/ref=sr_1_3?ie=UTF8&qid=1391296865&sr=8-3&keywords=12+by+3+mm+magnet).
Assembly:
If any interest, to follow.
Date de publication | 28/03/2017 |
Technologie | FDM |