3D Printer Vibration Dampening Feet
3D Printer Vibration Dampening Feet
3D
Published 2017-03-08T19:13:09+00:00
######################################################################
UPDATE: I have discontinued using these vibration mounts. They do quiet the vibration transmitted to the table but I believe that they may introduce artifacts into the print by allowing the printer to move on the soft mounts. This is not desirable. I am checking cubes printed with and without the mounts. I'll let you know what I find. I suggest you hold off making these until I can report back.
######################################################################
I've been running my printer on a piece of carpet to isolate vibration. I've been looking for a more permanent solution and saw that some people have used tennis balls with attachment mounts. I wanted something smaller and found these foam rubber golf practice balls. They are made of medium density foam rubber with a tough exterior. They are only 41 mm in diameter which make them compact and low profile. I designed a mount that accepts a 1/4-20 or 7 mm hex head screw. The screw pushes in from the bottom and rests in a hexagon shaped pocket. The mount screws into the threaded end of my 2020 extrusion on my HyperCube printer. The balls are retained by four small barbs on the inside rim of the mount. They are pressed firmly in place but can be pried out if replacement is needed. The balls are cheap and readily available. Here's what I used:
https://www.amazon.com/PrideSports-Practice-Balls-Count-Yellow/dp/B00466W9X0
Be sure to print with supports.
Notes:
You must use supports
I printed in PLA but ABS or PETG would be good.
Extruder 210C
Bed 40C
| Date de publication | 08/03/2017 |
| Technologie | FDM |
