anet a2 mainboard offset (30mm)
anet a2 mainboard offset (30mm)
3D
Published 2017-04-26T18:13:33+00:00
This is a remix to fit my Anet A2 from the original found here: http://www.thingiverse.com/thing:2164045
I modified this so that I can move the PCB board away from the print surface and part fan, and moves the PCB board even further than the original was designed by using different holes that I added.
This object was made in Tinkercad. https://www.tinkercad.com/things/igOecjTCZEv
Supports are going to be required.
I printed this at 0.2, but would probably go up to 0.3 next time to save time as it's a very simple print and should look fine.
If I were to print it again, I would print it with full supports, and in the orintation I shared it in, instead of printing it upside down with supports only touching the build platform, however it did finish fine (for me) and probably saved around 30% of the support material. Up to you.
Printed at 50mm/s with 25mm/s exterior wall speed, in purple PLA+ at 210/HE 50/BED
| Date de publication | 26/04/2017 |
| Technologie | FDM |
| Complexité | Medium |
