Anker USB Hub - Surface Pro 4 Mount
Anker USB Hub - Surface Pro 4 Mount
3D
Published 2018-05-25T15:19:51+00:00
Designed this mount to allow mounting the Anker 4-Port USB 3.0 Ultra Slim, on a Surface Pro 4.
This makes is really easy to travel with the small hub, it also allows it to be used as a vertical stand, making it easier to connect devices while working.
The Anker 4-Port USB 3.0 Ultra Slim is a great little hub, but the cable is very small, so using it with a Surface Pro, it ends up hanging. By slipping it into this mount, it can easily be slipped onto the stand of the Surface Pro 4.
It is a tight fit with my print, but I modelled clearance.
If you print with the base flat on the build plate, it will print really clean with no supports needed, since it prints on an angle.
I printed it rough and quick in my case, using a 1mm nozzle, with:
Two shells
.2 layer height
40% infill, but just adjust to needed to ensure solid surfaces. With a .4 nozzle, 20% is likely enough.
| Date de publication | 25/05/2018 |
| Technologie | FDM |
| Complexité | Easy |
| Sans support | YES |
