Apple Watch Charging Stand
Apple Watch Charging Stand
3D
Published 2018-09-09T01:12:14+00:00
Apple watch charging stand. The design is modular so I should be able to adapt it to other chargers, including other watches if anyone is interested. The base (blue bit) is optional, I used a flexible filament to hide the hole you fish the USB cable through and give it a little grip on a table surface. You can also print it in a regular material, should have enough tolerance. The charge holder is not glued in these pictures, The guide post/hole solution provides a good connection... at least on my machine. Your results may vary. This was done on a stock CR10s so nothing special.
No supports needed, but make sure the outside faces are down on the charge holder parts. Think one imports by default on the wrong side.
Settings for the ones in the picture are .2 layer hight, overall 80mm a second print speed (S3D sliced). Used atomic filament, 205 print temp, 215 I think on the first layer.
| Date de publication | 09/09/2018 |
| Durée d’impression | 180 - minutes |
| Quantité de filament | ~40g |
| Sans support | YES |