Battlement Ring
Battlement Ring
3D
Published 2017-09-12T14:56:47+00:00
This design is an entry into the Vectary Design Competition sponsored by MakeX
A ring design, made to resemble the decorative battlement on a medieval castle. You can print one in your favorite color for a simplistic look, or print two and press them together as shown in the picture.
Both prints are Filamentum PLA, the light one is Rapunzel Silver, the dark one is Vertigo Grey.
Note that the ring is very small, the inner diameter is approximately 16mm, so you might want to scale it up to fit.
Enjoy :)
Created with VECTARY
I printed this at very low speed and low temperature, with extrusion set to 99%. This helped with stringing, and distortions caused by vibrations.
Sliced in Cura and printed on the Prusa i3 MK2S.
Layer Height: 0.05 mm.
| Date de publication | 12/09/2017 |
| Technologie | FDM |
| Complexité | Easy |
| Sans support | YES |
