Camera Mount Hitec AEE Action Camera MD10
Camera Mount Hitec AEE Action Camera MD10
3D
Published 2018-01-24T12:18:33+00:00
This is a 30 degree angle mount designed for the MD10 camera sold by Hitec RCD to be printed in TPU (Ninjaflex etc). There were no mounts available for this great little HD camera so I designed one up thanks to Hitec RCD. It's intended to be zip-tied or Velcro strapped to the quad frame. Thanks and let me know how you like it.
Printer Brand:
Airwolf 3D
Printer:
Rafts:
No
Supports:
Yes
Resolution:
.15 to .3
Infill:
25%
Notes:
Printed with 3mm Ninjaflex on Airwolf HDx and .5 nozzle from Matterslice.
235 extruder temp
40 Bed temp
2 perimiters
3 bottom layers
4 top layers
Speed 20mm/s infill and inside perimeter
Speed 15mm/s outside perimeter
Support: Lines, 35 degree overhang, 2.5mm spacing, X/Y spacing .65, Z .2 spacing, support everywhere.
Taking the support out is not too bad but using an exacto knife helps liberate some areas. Using a dremel drum sander bit removes any leftover support and for smaller areas a carbide bit takes care of anything else.
| Date de publication | 24/01/2018 |
