Center Pivit 2X Supported Spool side Mount
Center Pivit 2X Supported Spool side Mount
Published 2019-10-04T18:30:10+00:00
This design uses two supports that hold the spool just off the side of a Makerbeam type printer, primarily for a Tevo/ Creality style printer. By placing the pivit point at the center of the spool it helps reduce the resistance you get when you use the designs where the spool is sitting on top of bearings or bars. This should provide less resistance on the extruder gear.
The rod (P2A) is long enough to have the right bar on the front of the Z beams and the left one near the back. The spacer will help ensure the spool holders don't come out from inside the spools.
Center wheel is sized for ZYLTech PLA Rolls.
Parts:
- Spool Holder TAS v1_P1 : Insert two bearings into each of the discs. Use glue to hold them in and get firm grip.
- Spool Holder TAS v1_P2A: Short rod that runs through everything
- Spool Holder TAS v1_P2B: Long rod that runs through everything (Your choice on which you want to use.)
- Spool Holder TAS v1_P3: Spacer to keep the wheels from comming out of the spool.
I prined it with two perimeters and five surface layers.
Everything should lay flat; the long rods have a flat side to aid in it's printing.
The arms have a flat side for the screw hole; this flat side should be facing up.
Using a screw and nut to hold it on is optional.
Date de publication | 04/10/2019 |
Sans support | YES |