cross of scorpio
cross of scorpio
3D
Published 2019-10-06T05:55:11+00:00
The cross of Scorpio
The name comes from the 1st thought of a name because it’s a pencil gun in a cross gun style designed to shoot Off Canadian sized number 2 colored pencils
And it’s a pencil gun which means it shoots pencils but this is meant for (responsible owners only ,and check your local laws)
This is only safe if its handled properly , safely and responsibly which is the responsibility of all shooters
Please credit is due at any depiction Including the disclaimer
By downloading or 3dprinting you agree this & accept its at your own risk of any liabilities including negligence or use
instructions
american/canadian number 2 pencils are recommended
* for attaching the rubber bands like the designer does is to attach a rubber band and stretch it across the rear up to the next fork.
& just a update a size 64 rubber band should make the pencil gun shoot pencils better & faster
but require different stringing then the size 117b rubber band method
* be sure to stetch the elastic with the pencil with both halfs of the rubber band at a angle and then load in the pencil into the slot
* use general use plastic
*wear eye protection
* update oct/19 /2019 feel free to experiment with different rubber bad sizes though large sized rubber bands allow easier and more rapid loading
| Date de publication | 06/10/2019 |
| Durée d’impression | 1 - 2 minutes |
| Quantité de filament | roughly 40 grams of pla at 50% infill |
| Dimensions | 132.08 mm x 76.2 mm x 16.289 mm |
| Sans support | YES |
