Eyepiece converter for microscope from 23mm to 30mm
Eyepiece converter for microscope from 23mm to 30mm
3D
Published 2015-04-23T08:34:18+00:00
The stereo zoom microscope I recently bought came with 30 mm diameter eyepieces. I also bought another set of eyepieces but these were 23mm diameter.
So I designed the attached converter so that the 23 mm diameter eyepieces would fit in the microscope.
There will be shrinkage due to the nature of whatever filament is used - mine were made with ABS. The outer diameter fit the microscope well, the inner diameter had to be sand papered to fit. The bonus
is that sand papering made an exact snug fit on the 23mm diameter eyepieces.
I rolled up a piece of coarse sandpaper into a cylinder and used that to slightly widen the inner diameter for the snug fit.
Print at 0.2 mm layer height, with 10% infill. This uses 6 g of filament and takes 1 hour and 3 minutes.
| Date de publication | 23/04/2015 |
| Durée d’impression | 63 - 73 minutes |
| Quantité de filament | 6 g |
| Dimensions | 34 mm x 34 mm x 23 mm |
| Complexité | Very Easy |
