Fringe Case #3 - Yamaha YG450D Generator Choke Bushing
1,352
views
30
downloads
Community Prints
Add your picture
Soyez le premier à partager une photo de l'impression de cet objet
0 comments
Loading comments...
Fringe Case #3 - Yamaha YG450D Generator Choke Bushing
3D
Published 2020-04-12T04:35:23+00:00
0
0
Add to Collection
Description
Yet another fringe case, one off product that no one may never have need for. This time we are replacing the choke rod bushing on a Yamaha YG450D generator. The original is a rubber piece, so you might could print this in TPU or other flexible material. I just used PLA and it works fine. In addition to this piece, you will need an o-ring to hold the part in place. The o-ring I used is 4mm inside diameter by 1.45mm thick. Just put the bushing in place through the mounting plate, slide the o-ring up into the groove to hold it in place and run the choke rod through the bushing. Easy peasy.
Licence
Technical Information
Date de publication | 12/04/2020 |
Sans support | YES |
More Information
Object Parts