Gyrocopter Dota 2
Gyrocopter Dota 2
Published 2015-07-22T20:53:03+00:00
This drone model is part of the MicroDrone 3.0 design competition.
The file contains 2 Gyrocopter model. One is the original without edt and the second one has been edited for the MicroDrone Competition.
After serving through a lifetime of wars, upheaval, riots, and revolutions, the brass figured Aurel had seen enough. But in addition to a few trinkets and his considerable pension, the erstwhile engineer left with something far more interesting: a long-forgotten, incomplete schematic for a Gyrocopter, the world's first manned, non-magical flying device. Retiring to the tropical obscurity of the Ash Archipelago with little else but time and money, he set to work building the device. As the years wore on and the remains of failed prototypes began to pile up, he began to wonder if mechanical flight was even possible. A decade and a day after his retirement, on a sunny afternoon with a southerly breeze, Aurel sat in his latest attempt bristling with indignation and expectant failure. With a grunt of effort he pulled the ignition cord and covered his head, waiting for the inevitable explosion. However to his great surprise he began to lift and, following a few panicked adjustments, stabilize. Within an hour, he was ducking and weaving with the breeze, level with the gulls, and Aurel found himself filled with the breathless wonder of flight. As dusk settled in he set a course back to his workshop, but no sooner had he turned his craft when a cannonball tore through his tailfin. Disentangling himself from the wreckage, he swam toward the nearest piece of land in sight, and cursed to see the ship responsible for the cannonball collecting the debris. Days later, when Aurel returned to his workshop, he set to work on yet another gyrocopter, this one capable of carrying a much heavier, more dangerous payload.
There are two files - The original - The edited one for the competition. Please print in high quality (layer high:0.1 or 0.02).Fill density (30 - 50%) Support is required, as the part is a bit complex, However, the FDM printer should be able to print everything in one go. My Ultimaker 2 printer were able to do that. If possible please paint it to give a good look. Thank you Very Very much for your support.
Date de publication | 22/07/2015 |
Dimensions | 140 x 92 x 61 |
Complexité | Difficult |