Hakko T12 & Ryobi Soldering Station
Hakko T12 & Ryobi Soldering Station
Published 2020-10-24T23:45:18+00:00
Remixed the awesome TS100 Soldering Iron Ryobi by rkolibar to encase a T12 Hakko soldering station DIY kit. Borrowing also from Quicko Mini STC T12 Panel I was able to combine them into an all-in-one soldering station. The holder was remixed from Hakko T12 Handle (clone) Holder by DonJuanito to fit my Hakko T12 soldering iron handle.
The solution differs a little bit from others around here, in that the main body is all one piece, no separate panel for the LCD/Controls. This makes the unit very compact, although at the cost of making assembly a little tricky.
Just remember not to solder the connector to the board until assembly time!!! I got over eager and had to desolder it for final assembly (I still didn't know what I wanted).
Note
In the pictures the power switch is on the outside of the case, I found this to be a mistake so I made some changes to mount the switch from the inside. The uploaded version reflects that change. Switch used: SS12F15
Preparation
Assembly
After the printing is done. Remove support material, cleanup as much as you can.
Battery(+) -> switch -> Positive(+) terminal in PCB.
Battery(-) -> Negative(-) terminal in PCB
Try to use Neon Green color to keep it "Ryobi accurate"!
Date de publication | 24/10/2020 |