Hydraulic ram
Hydraulic ram
3D
Published 2018-02-05T17:04:40+00:00
This is a hydraulic ram pump, it is a type of pump that does not need electricity to raise water, it is only worth the pressure exerted by gravity to generate a water hammer that raises the air pressure in the can and drives the Water.
This type of contraption is ideal for places where there is no electrical power.
This is an educational model, functional as long as it is perfectly sealed and the valves in place.
For assembly, a 250ml can and two m3 rods and two metric 3 nuts are needed, glue to assemble the parts and seal the pipes
Throughout these days I will print it and upload photos
Esto es un una bomba de ariete o ariete hidraulico , es un tipo de bomba que no necesita electricidad para elevar agua , tan solo le vale con la presión ejercida por la gravedad para generar un golpe de ariete que eleva la presión de aire en la lata e impulsa el agua.
Este tipo de artilugio es ideal para lugares donde no hay energía electrica.
Esto es un modelo educaciónal , funcional siempre y cuando este perfectamente sellado y las valvulas en su sitio.
para su montaje es necesaria una lata de 250ml y dos varillas de m3 y dos tuercas de metrica 3 , pegamento para ensamblar las partes y sellar las tuberías
a lo largo de estos días lo imprimiré y subiré fotos
1.1 supportvalve1 was replace by valve 1-1 and support valve 1-1
support valve 1-1 is a guide for a m3 screw.
Ram fixed without support is now available
Actualizacion 1.1 suportvalve1 ha sido sustituida por support valve 1-1 y valve 1.1
print over 30% infil cause water pressure can break the plastic .
the valves can be replaced by coins with a hole.
the valves should be printed with pla or hips because they are more rigid plastics and do not absorb the impact
| Date de publication | 05/02/2018 |
| Durée d’impression | 5 - 10 minutes |
| Technologie | FDM |
| Complexité | Easy |